DMX In/Thru Breakout — Standard

Skip the panel-mount XLR soldering. Wire your decoder cleanly with a JST-XH jumper and Wago spring terminals.

A no-fuss PCB that gives your DMX in and thru jacks a proper home. Terminate your XLR5 connectors to the board, run a JST-XH jumper to your decoder, and land your DMX cable on Wagos — no crimped ferrules, no screw-terminal slip, no microscope work inside a project box.

Designed for low-budget RGB/RGBW decoders where opto-isolation isn't critical: scenic practicals, prop builds, set dressing, prototype rigs, and anywhere you control the power and signal chain end-to-end.

If you're touring it, installing it, or sharing power with anything sensitive, grab the OPTO version instead.

Specs

• XLR5 in/thru footprints (panel-mount or pigtail)
• JST-XH header for decoder connection
• Wago 803-style spring terminals for incoming DMX
• Pin 1 ground lift jumper
• No opto-isolation